Ewent EW7048 Manual download pdf (Page 3)

ENGLISH

• Mounting foot

• USB cable

• Power supply

• 4 hard disk mounting screws

• 2 housing screws

• Screwdriver

• Manual

• CD-ROM with Turbo software

2.0 Mounting a hard disk

1. Carefully take the back plate of the casing. Unscrew the back plate if necessary.

2. Pull the front out of the casing, and then slide the cradle out.

3. Carefully place the hard disk in the cradle. Be careful, do not force or twist the

cables.

4. Screw the four hard disk mounting screws onto the holes on left and right side of

the cradle with the hard disk.

5. Slide the cradle back into the casing.

6. Once the cradle has been fit, press the back plate back onto the casing and use

the two supplied screws to fix the back plate tightly on the casing.

3.0 Connecting the EW7048

You can use the EW7048 R1 on common operating systems. The general steps to

connect the enclosure to your computer:

1. Connect the power cord to the ‘Power’ connection on the casing.

2. Connect the USB cable to the ‘USB’ connection on the casing.

3. Connect the power cord to the power supply and connect the power supply to a

wall outlet.

4. Connect the USB cable to a free USB port of your computer.

5. Make sure the power switch is set to ‘1’ to start the device.

6. Your computer will automatically recognize the device and usually will find a

‘USB mass storage device’.

4.0 Preparing your hard disk for usage

The following steps are only needed when using a new hard disk!

4.1 Windows 2000/XP/Vista

1. Right click the ‘My Computer’ icon.

2. Click ‘Manage’.

3. Select the option ‘Disk Management’ from the left side of the screen.

4. Right click the new hard disk.

1 2 3 4 5 6 7 8 9

No comments

Ewent EW7048 Manual Page 3