Ewent EW7009 Manual download pdf (Page 12)

ENGLISH

1. Make sure the EW7009 is completely turned off.

2. Take your SATA hard disk with the label on top and the SATA connector at the

bottom. Make sure the SATA connection is pointed towards the hard disk slot of

the EW7009. If correct, the connectors of the EW7009 and hard disk are perfectly

aligned.

3. Carefully slide the hard disk into the EW7009. The hard disk will ‘click’ into it’s

position.

Hint: Do not disconnect the hard disk from the EW7009 while in use. The EW7009

needs to be turned off. This way, damage to both the hard disk and EW7009 can be

prevented.

3.0 Connecting the EW7009 to your computer

There are two methods to connect the EW7009 to you computer: By using the USB

port and by using the eSATA port. Using the eSATA port, a higher transfer speed can

be achieved. However, not every computer is equipped with an eSATA port. In that

case, the USB port can be used.

3.1 Connecting the EW7009 using USB

1. Make sure the hard disk has been mounted as described in chapter 2.

2. Connect the supplied USB cable to the USB connection of the EW7009.

3. Connect the other side of the USB cable to a free USB port on your computer.

4. Connect the cable of the power supply to the ‘DC IN’ connection of the EW7009.

5. Connect the power supply to a wall outlet.

6. Press the ‘Power’ button of the EW7009 to turn the EW7009 on.

7. Your computer will automatically detect the hardware of both the EW7009 and

the SATA hard disk. If correct, Windows will detect a ‘USB Mass storage device’.

Note: USB is ‘hot swappable’, which means there is no need to turn off your computer

while connecting the EW7009 using USB.

4.0 Using the EW7009

The moment Windows has found the hardware and has finished installing this

hardware, the EW7009 is ready to be used. If a hard disk has been mounted which

has been pre-used, then you are able to use the hard disk to transfer data. However, if

the hard disk you have mounted is brand new, and has not been formatted before, you

have to prepare the hard disk for usage with Windows. Use the following steps to do

so.

Note: Make sure you must safely remove the EW7009 from your computer.

Click ‘Safely remove hardware’ icon on the taskbar and you will see al list of

devices. Click the device you want to remove.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 67 68

No comments

Ewent EW7009 Manual Page 12